Piret, Jean PascalJean PascalPiretBondarenko, Olesja M.Olesja M.BondarenkoBoyles, Matthew S.P.Matthew S.P.BoylesHimly, MartinMartinHimlyRibeiro, Ana R.Ana R.RibeiroBenetti, FedericoFedericoBenettiSmal, CarolineCarolineSmalLima, BraulioBraulioLimaPotthoff, AnnegretAnnegretPotthoffSimion, MonicaMonicaSimionDumortier, EliseEliseDumortierLeite, Paulo Emilio C.Paulo Emilio C.LeiteBalottin, Luciene BottentuitLuciene BottentuitBalottinGranjeiro, José MauroJosé MauroGranjeiroIvask, AngelaAngelaIvaskKahru, AnneAnneKahruRadauer-Preiml, IsabellaIsabellaRadauer-PreimlTischler, UlrikeUlrikeTischlerDuschl, AlbertAlbertDuschlSaout, ChristelleChristelleSaoutAnguissola, SergioSergioAnguissolaHaase, AndreaAndreaHaaseJacobs, AnAnJacobsNelissen, IngeIngeNelissenMisra, Superb K.Superb K.MisraToussaint, OlivierOlivierToussaint2025-09-012025-09-012017-06-0110.1007/s00204-016-1897-22-s2.0-85006355458https://d8.irins.org/handle/IITG2025/2933027942788The rapid development of nanotechnologies and increased production and use of nanomaterials raise concerns about their potential toxic effects for human health and environment. To evaluate the biological effects of nanomaterials, a set of reliable and reproducible methods and development of standard operating procedures (SOPs) is required. In the framework of the European FP7 NanoValid project, three different cell viability assays (MTS, ATP content, and caspase-3/7 activity) with different readouts (absorbance, luminescence and fluorescence) and two immune assays (ELISA of pro-inflammatory cytokines IL1-β and TNF-α) were evaluated by inter-laboratory comparison. The aim was to determine the suitability and reliability of these assays for nanosafety assessment. Studies on silver and copper oxide nanoparticles (NPs) were performed, and SOPs for particle handling, cell culture, and in vitro assays were established or adapted. These SOPs give precise descriptions of assay procedures, cell culture/seeding conditions, NPs/positive control preparation and dilutions, experimental well plate preparation, and evaluation of NPs interference. The following conclusions can be highlighted from the pan-European inter-laboratory studies: Testing of NPs interference with the toxicity assays should always be conducted. Interference tests should be designed as close as possible to the cell exposure conditions. ATP and MTS assays gave consistent toxicity results with low inter-laboratory variability using Ag and CuO NPs and different cell lines and therefore, could be recommended for further validation and standardization. High inter-laboratory variability was observed for Caspase 3/7 assay and ELISA for IL1-β and TNF-α measurements.falseIn vitro assays | Inter-laboratory studies | Interference | Nanoparticles | Standard operating proceduresArticle143207382315-23301 June 201738arJournal36